Manual

2-8 Installation
5. Will this tool control dual applicators?
6. One applicator has been configured. Do you need another applicator?
7. Will the SC-300 Swirl Tool use a needle finder?
8. Will the SC-300 Bead Tool use a needle finder?
9. Will the SC-300 Monofilament Tool use a needle finder?
10. Do you require the LowAir tool? (Swirl Applicator only)
11. Do you require the HighAir tool? (Swirl Applicator only)
ID Systems Configuration
If you selected ID Systems in the Configure Dialog box, you will be prompted to select your ID System.
See Figure 2-6.
Figure 2-6 ID Systems Configuration
Fluid System Configuration
If you selected Fluid System in the Configure Dialog box, you will be asked if your fluid system has a
flow meter option. See Figure 2-7.
Figure 2-7 Fluid System Configuration
" NOTE After you have responded to all of the questions, the ECNT Operator Screen opens and
you are ready to begin your session.