Manual

Installation 2-7
Robot Configuration:
If you selected Robot in the Configure Dialog box, you will be prompted to select your system
(Figure 2-4) and respond to the questions in paragraph 11 above.
Conveyor Configuration
If you selected Conveyor in the Configure Dialog box, you will be prompted to select your system and
respond to the following questions:
1. Is your conveyor left to right?
2. Is this a chain conveyor?
3. Does this conveyor have clamps or pins in the dispense station?
4. Is there a sensor to detect that the product pins or clamps are engaged?
5. Do you have an inverter?
6. Is your inverter upstream?
Tools Configuration
If you selected Tools in the Configure Dialog box, you will be prompted to select your tools. See
Figure 2-5.
Figure 2-5 Tools Configuration
Depending on the applicator and options selected, you will be prompted to respond to some or all of the
following questions.
1. Does this applicator have tilt?
2. Does this applicator have rotate?
3. Does this applicator have incremental rotate (0, 90, 180, and 270 degrees)?
4. Does this applicator have a nozzle extension?