Manual

2-4 Installation
2.5.2 Reconfigure
" NOTE Upon initial installation of the software, or if you change your system hardware or
reinstall the software, use the Reconfigure feature to run the setup procedure.
To reconfigure ECNT:
1. If necessary, install the ECNT software as instructed in the Installation section.
2. After the installation is complete, you may click on the Windows
Start menu and select
Programs > ECNT to start the ECNT software.
! The ECNT Operator Screen shown in Figure 2-1 opens.
" NOTE The product program from the previous session opens when you start ECNT.
Figure 2-1 ECNT Operator Screen
3. Select Edit > Edit Mode from the ECNT Operator Screen menu bar to access the ECNT Edit
Screen. See Figure 2-2.