Manual

2-2 Installation
2.4 Installation Procedure
Most of the standard installation process is automated. You will be prompted to approve file locations and
accept defaults. Since ECNT is a true Windows NT software package, installing ECNT follows standard
Windows installation procedures.
CAUTION! The ECNT installation procedure should be performed by an application
engineer, Information Systems manager, computer programmer, or trained
service technician.
CAUTION! DO NOT attempt to install ECNT on Windows 95 or Windows 98.
To install ECNT:
1. Perform a dispensing system startup in accordance with the manual applicable to your
dispensing system.
2. If any Windows programs are running, close them.
3. Insert the ECNT CD-ROM into the CD drive of the dispensing system computer.
! The installation procedure should launch automatically. If it does not, perform the Steps
below. If the installation procedure does launch automatically, skip to Step 10.
4. Click on
Start in the lower left-hand corner of the computer screen.
5. From the Start menu, select
Run.
6. In the Run dialog box, click on
Browse.
7. Locate the CD drive from the directory and double-click on it.
8. Double click on
Setup.exe.
9. Click on
OK in the Run dialog box.
10. Select “
Typical installation” unless otherwise instructed.
! If you are asked to input the dispensing system serial number and/or model, you can find
the information on the tag on the back panel of the dispensing system. Enter the
information when requested.
! If you are asked to insert the “Cal map” diskette, you can find the disk in a pouch located
on the inside of the lower front cabinet door.
! Contact Asymtek Technical Support for help if necessary.