Upgrade Kit Owner manual

6 Upgrading the DP-3000

4. Pull gently down on the slide retainer to remove it.

5. Using the 2.5-mm hex key, loosen the two assembly screws that attach the receiver block to

the pump.

! These screws are captive and should remain attached.

6. Pull the receiver body gently downward, and remove it.

PRIM

FULL

LIMIT

STO

OCK

1/1

3/4

1/2

1/4

PRIM

Figure 2-5 Using the Piston Extraction Tool

7. Place the piston extraction tool around the piston, aligning the flats on the piston with the

opening on the beveled end of the piston extraction tool. See Figure 2-5.

" NOTE The piston must be fully extended for removal and installation. To fully extend the

piston, perform steps 8–11.

8. Click on Run a Program in the Fluidmove Main Window.

9. Click on Setup.

10. From the Setup menu, double-click on Purge Infinite.

! If you have removed the pump from the dispensing system, you can use the upper knob

to extend the piston instead of performing the following procedure.

! If you do not see Purge Infinite in the Setup menu, you will need to perform the following

instead:

a. Return to the Main Window.

b. Click on Configuration.

Wrench

Piston Extraction

Tool

Piston