Upgrade Kit Owner manual

Upgrading the DP-3000 9
11. Position the gears so that they are the same height.
CAUTION! It is important that the gears are properly aligned for the pump to function
correctly. Gears that are not aligned to the same height may shear, causing
damage to the pump.
12. When the gears are properly positioned, use the 1/16-inch hex key to tighten the set screws
in the gears.
13. Replace the gear cover and gear cover screws.
DP-3000
AN
O
R
D
S
O
N
C
O
M
P
A
N
Y
PRIME
FULL
LIMIT
STOPCOCK
1/1
3
/4
Figure 2-6 Removing the Gear Cover
DP-3000
AN
ORD
SON
CO
M
P
AN
Y
1/1
3/4
1/2
PRIME
FULL
LIMIT
STOPCOCK
Figure 2-7 Removing the Gears
Feed Screw Gear
Gear Cover
Motor Gear
Gear Cover Screws
Motor Shaft
Feed Screw Shaft
Set Screws