Instruction Manual

Installation 15
Software Configuration
Once the DP-3000 is completely installed on your dispensing system, the Fluidmove software needs to
be configured to accommodate the new pump.
FmNT/FmXP:
1. Start the Fluidmove software.
! If Fluidmove is already running, save all currently loaded dispensing programs. This
procedure requires the computer to be restarted. Any unsaved changes to the currently
loaded dispensing program may be lost if not saved.
2. In the Main Window, click on Configuration>Setup Valves.
3. Select DP-Series from the Active Configuration list. See Figure 2-9.
Figure 2-9 Valve Software Configuration
4. Click on OK.
! A message box opens indicating that Fluidmove must be restarted in order for the
changes to be implemented.
5. Click on OK to restart Fluidmove.
6. Perform the Installation Verification Test. See “Installation Verification Test” later in
this section.
" NOTE Refer to the Fluidmove User Guide or Online Help to further customize the pump/valve
to fit your particular application requirements.