Instruction Manual

12 Installation
Figure 2-6 Mounting Dovetail Assembly
4. Place the flat washers onto the M4 screws.
! It is important to use washers with these screws to prevent damage to the aluminum on
the dovetail receiver assembly.
! Use Loctite Removable Threadlocker #242 on the screws before replacing them.
5. Insert the four 10-mm M4 screws as shown in Figure 2-6 and use the 3-mm hex key to
tighten the screws and secure the assembly to the Z-head mounting plate.
6. If you are using a Height Sensor with your DP-3000, use the 3-mm hex key to attach the
Height Sensor bracket to the dovetail receiver assembly. See Figure 2-2. If you are not using
a Height Sensor with your DP-3000, skip to Step 8.
7. Use the Phillips-head screwdriver to attach the Height Sensor to the Height Sensor bracket.
8. Configure the DP-3000 with a dispensing chamber, stopcock, desired syringe size, proper
Luer fittings, syringe clip, cartridge sleeve, if necessary, and needle as required for your
application. Refer to the Operation section for instructions.
9. Position the Quick Release Mate onto the back of the DP-3000 as shown in
Figure 2-3.
10. Coat the four M3 screws with Loctite Removable Threadlocker #242.
11. Insert the four screws through the Quick Release Mate into the back of the pump, as shown
in Figure 2-3, and use the 2.5-mm hex key to tighten them.
12. Flip the orange locking lever on the Quick Release Mate all the way up.
! This is the unlocked position.
! The lever is retained in the upright position by a detent; you will feel a click as it engages.
M-4 Screws
Dovetail Receiver
Assembly
Z-Head Mounting
Plate
M-4 Screws