Installation Owner's manual

Safety

• Installation procedures should only be performed by a trained service technician.

• Before performing any of the System installation procedures in this guide, please

review the Safety section presented in the DispenseMate 580 Series User Guide.

• Disconnect and place a warning tag on the Main Power Inlet before performing

maintenance or service.

• Disconnect and place a warning tag on the Main Air Pressure Gauge and Regulator

before performing maintenance or service.

• When adjusting pressure with regulators, always reduce the pressure below the

desired range before turning the pressure back up.

• There is an important correlation between the position of the Dispensing Valve tip and

the Height Sensor Probe. Always adjust the Height Sensor Probe after a valve or

needle length change.

Tools and Materials Needed:

Uncrate and

Place the

Dispensing

System

• Band Cutter

• Hammer

• Flat Bar

• Appropriate personal protective equipment

1. Locate and remove the envelope on the outside of the shipping crate. Open the

envelope and locate the shipping list.

2. Cut the four bands that secure the lid to the crate. Remove the lid, four cardboard

corners, and plastic sleeve.

3. Remove the poly bag from the unit and cut the bands that secure the Dispenser to the

crate bottom.

4. Place the Dispensing System near the installation site.

5. Remove all perimeter packaging material from the dispensing area.

6. Remove all tie wraps, tape, foam packaging material, and warning tags from the

Dispensing Head and Tooling Plate.

"NOTE Location of packaging materials to be removed is indicated by the presence

of warning tags.

7. Use the flat bar and hammer to remove the crate and unpack the accessories crate.

! As you unpack each item inside of the box, identify the item, locate it on the

shipping list, and place a checkmark next to the item.

WARNING! CAUTION!

Personnel should wear gloves and safety glasses while removing the

top and sides of the crate.

"NOTE The contents of the accessories crate will vary depending upon the options

ordered with your Dispensing System.