Manual

42 Maintenance

Item Description

1 Tooling Plate

2 Y-Axis Cables

3 Z-Axis Cables (inside)

4 X-Axis Cables (inside)

Figure 5-3 Mechanical Drive Cables

Lubricating the XYZ-Axis Linear Guides

" NOTE To perform the following procedure, you will need Asymtek Grease Kit P/N 7203262.

The kit contains a grease syringe.

1. Remove the X- and Y-axis covers as described previously in this section.

2. Load the grease cartridge into the grease syringe.

3. Purge the air from the grease syringe by dispensing grease until a solid stream flows from the

syringe.

4. Using the Position Controls, move the Dispensing Head to the front of the dispensing area

and lower it as much as possible.

! The needle and Height Sensor probe should not touch the substrate.

5. Turn OFF the Main Power Switch.

6. Locate the small access hole on the X-Axis bearing housing. See Figure 5-4.

7. When finished, replace the axis covers and tighten the screws.