Manual

38 Operation
System Shutdown
Routine shutdown may vary depending on your particular requirements. However, it is recommended that
you incorporate the following procedures into your production shutdown routine:
Production Shutdown
To shut down at the end of a production shift:
1. Wait for the dispensing program to complete and verify that all motion has stopped.
2. Unload all workpieces.
3. Remove the Dispensing Valve and clean as instructed in the appropriate valve manual.
4. Exit FmNT.
5. Exit Windows NT and turn off the Computer.
" NOTE Make sure Windows NT completely shuts down before turning off the Computer.
6. Turn the Main Power Switch on the back of the system to the
OFF (0) position.
Service Shutdown
To shut down for service:
1. Perform steps 1-6 above under “Production Shutdown” above.
2. Disconnect the Main Power cable and place it in a locked box.
3. Disconnect the facility air hose and place a warning tag on the Main Air Inlet.