Manual

Operation 29
4. When the FMNT Message 30416 - Dispenser Motor References Not Found appears, click OK
to Home the Dispenser (Figure 4-1).
Figure 4-1 FmNT Message 30416
! The FmNT Main Window will open. See Figure 4-2.
Figure 4-2 FmNT Main Window
5. Check to make sure the Dispensing Head is in the proper Home position.
" NOTE If you receive any error messages, refer to the Troubleshooting section or to the FmNT
User Guide or Online Help.
Positioning the Dispensing Head
When necessary, an operator can use FmNT position (jog) controls to reposition the Dispensing Head in
the X, Y, and Z-axes. These position controls can be operated using the Mouse to click on-screen buttons,
or by pressing key combinations on the Keyboard. Both methods are described below.
" NOTE These procedures assume that the Computer and the dispensing system have been turned
on as specified under “Startup” in this section.