Manual

28 Operation
Startup
System Startup
If necessary, refer to the figures in the Introduction section to identify system components.
To power on the dispensing system:
1. Verify that the main power cord is connected to the Main Power Inlet and the facility power
source.
2. Verify that the facility air is at the recommended pressure level and connected to the Main
Air Pressure Regulator Inlet. See Figure 4-7.
3. Turn the Main Power Switch on the back of the system to the
ON (I) position.
4. Turn the Computer power switch to the
ON (I) position.
! The system Computer should begin the boot up sequence.
5. Check the EMO button to see if it has been activated. If it has been activated, deactivate it by
turning the red knob clockwise until the knob pops out.
6. Make sure the Interlock signal is not interrupted. Close the dispensing system front doors if
applicable.
7. Press
Start on the Control Panel.
! The dispensing system should be in a powered-up state and the digital gauges should be
on. If not, make sure the power cord is properly connected to the dispensing system and
to an active facility power source.
Starting Fluidmove for Windows (FmNT)
The FmNT startup procedure assumes that FmNT is already installed on your computer and that the
computer is turned ON and running Windows NT.
To start FmNT:
1. Click on
Start in the lower left-hand corner of your Computer screen.
2. Select
Programs from the Start menu.
3. Select
FMNT from the Programs menu.
" NOTE Alternatively, you can double-click the FMNT icon on the Windows NT desktop.
CAUTION! Do not press any keys or the mouse while FmNT is starting unless prompted to
do so.
! FmNT will now start. It will check to see that all the Input and Output (I/O) devices for
your dispensing system are communicating properly with FmNT.