Manual

22 Installation
Uncrating and Placing the Dispensing System
Tools and Materials Needed:
• Band Cutter • Hammer
• Appropriate Personal Protective Equipment • Flat Bar
To uncrate and place the dispensing system:
1. Locate and remove the envelope on the outside of the shipping crate. Open the envelope and
locate the shipping list.
2. Cut the four bands that secure the lid to the crate. Remove the lid, four cardboard corners, and
plastic sleeve.
3. Remove the poly bag from the unit and cut the bands that secure the dispenser to the crate
bottom.
4. Place the dispensing system near the installation site.
5. Remove all perimeter packaging material from the dispensing area.
6. Remove all tie wraps, tape, foam packaging material, and warning tags from the Dispensing
Head and Tooling Plate.
"NOTE Location of packaging materials to be removed is indicated by the presence of red
warning tags.
7. Use the flat bar and hammer to remove the crate lid and unpack the accessories crate.
WARNING! CAUTION!
Personnel should wear gloves and safety glasses while removing the top and
sides of the crate.
! As you unpack each item inside of the box, identify the item, locate it on the shipping list,
and place a checkmark next to the item.
"NOTE The contents of the accessories crate will vary depending upon the options ordered with
your dispensing system.
Component Installation
Your DispenseMate 550 dispensing system is assembled and tested at the Asymtek factory. To protect
components during shipment, some are packaged in the Accessories Crate to be installed after arrival.