Manual

Installation 21
3 Installation
Overview
This section describes installation procedures for the DispenseMate 550 Series Dispensing System and
covers the following topics:
• Facility Requirements • Pneumatic Connections
• Uncrating and Placing the Dispensing System • Electrical Connections
• Component Installation • Connecting Power and Air Supply
Safety First
Before performing any of the system installation procedures in this section, please review the information
presented in the Safety section.
CAUTION! Installation procedures should only be performed by a trained service technician.
Facility Requirements
To ensure optimal performance and safety, it is necessary to install the dispensing system in a facility that
meets or exceeds the requirements listed in the Specifications section. If you have any questions about
facility requirements, please contact Asymtek Technical Support.
Work Bench Selection for the DispenseMate 553 and 555
The DispenseMate series 550 is designed to sit on top of a standard height (800 mm or 30 inch) work
bench, however work benches vary in stability and strength. The stability of the work bench will directly
influence the dispensing results. For best results, the use of an optional welded machine base (Asymtek
P/N 193418) is recommended.
WARNING! Make sure that your facility meets all requirements listed the Specifications
section. Failure to meet these requirements could result in serious bodily injury to
personnel and damage to the dispensing system.