Manual
16 Safety
Safety Warning Labels
Safety warning labels affixed to the DispenseMate 550 Series Dispensing System point out potentially
hazard areas and remind personnel to take necessary safety precautions. Table 2-1 describes safety labels
that may be affixed to the dispensing system. Locations of these warning labels are shown in Figure 2-1
and Figure 2-2.
WARNING! CAUTION!
Comply with all safety warning labels or serious injury to personnel or damage to
the dispensing system may occur. Worn or damaged labels should be replaced
with new labels having the same part number.
Table 2-1 Safety Warning Labels
Warning Type Symbol
Part
Number
(1)
Hazard
Electrical
(Shock Hazard)
70-0116-00
(1)
or
70-0050-00
(2)
This label warns of a high-voltage component that can cause
shock, burn, or death. Use extreme caution when working in or
around these areas.
Disconnect and lock out power before servicing.
General Warning
70-0055-00
This label identifies features that require special attention. These
features include moving parts (such as the Dispensing Head),
important power supply components (such as the Main Power
Switch), safety devices (such as the Interlock), or pneumatic
components (such as the Main Air Regulator and Gauge).
Fuse
(Fire Hazard)
70-0119-00
(1)
or
196667
(2)
This label warns of a fuse requirement that, if not met, can cause
fire or severe damage to the equipment.
For protection against risk of fire, replace a fuse with one having
the same type and current rating.
Disconnect and lock out power before servicing.
Heavy Object
(Lifting Hazard)
70-0118-00
(1)
or
196666
(2)
This label warns that the labeled component is heavy and can
cause muscle strain or back injury to personnel trying to lift it
Pressure Relief
Warning
322352
This label warns that the Pressure Relief Valve should be pulled
before performing service on the pneumatic system or opening
the fluid reservoir.
Pinch Hazard
198883
Middle Pinch
Pinch Hazard
7200879
Left Pinch Hazard
7200877
Right Pinch
Hazard
7200878
These labels warn of moving parts that can cause serious injury
to hands and fingers.
Disconnect and lock out power before servicing.
Notes: (1) Rectangular labels with symbols and text.
(2) Triangular labels with symbols only.