Manual

Safety 13
• Do not touch the Dispensing Head and other moving parts while the dispensing system is
operating.
• To prevent burn injury, wear thermal gloves when working around Heater Tooling and Fluid
Heaters.
• Follow Material Safety Data Sheet (MSDS) recommendations for the proper handling,
cleanup, and disposal of hazardous materials.
• Always wear appropriate personal protective equipment (PPE) as recommended by facility
safety practices and the material manufacturer’s MSDS.
• Know the MSDS recommendations for treatment of injury resulting from exposure to
hazardous materials.
• Before attempting to lift a load, take into consideration facility lifting and transport
precautions.
• Make sure that the Main Power Cable and Main Air Supply Hose are securely connected
before operating the dispensing system.
• Before performing maintenance or service on the Dispensing Head, position it at the front of
the dispensing chamber. This will provide easy access to components and limit exposure to
hazardous areas.
Preventing Dispensing System and Workpiece Damage
• Immediately push the EMO button if dispensing system or a workpiece is in danger of
being damaged.
• Use standard Electrostatic Discharge (ESD) precautions when working near sensitive
components. Always wear a grounding strap and connect it to the ESD ground before
handling workpieces.
• Immediately contain and clean up any caustic or conductive fluid spills as recommended in
the material manufacturer’s MSDS. If fluid gets into internal portions of the machine,
immediately contact Asymtek Technical Support.
• Follow all recommended system maintenance procedures.
• Always keep the dispensing area clear of any fallen workpieces or obstacles.
• Ensure that no air intakes or exhaust grilles are blocked when the system is in operation.