Instruction Manual

Running the VAPR Procedure 3
2 Running the VAPR Procedure
2.1 Overview
Priming commands are executed through the Fluidmove software. Prior to running the VAPR routine, the
Fluidmove software must be configured properly. The VAPR procedure can be run manually from the
Fluidmove Production Window or the Fluidmove Programming Window, but is most effective when
launched automatically during the valve offset routine. This section covers the following topics:
• Fluidmove Configuration
• Running the VAPR Procedure
WARNING! CAUTION!
Refer to the Safety section in the applicable dispensing system manual prior to
operating the dispensing system. Failure to comply with any of the safety
recommendations could cause serious injury to the user or damage to the
dispensing system.
2.2 Fluidmove Configuration
1. Power on the dispensing system.
 Refer to the applicable dispensing system manual if necessary.
2. Start Fluidmove.
 Refer to the Fluidmove User Guide if necessary.
3. In the Fluidmove Main Menu, select Configuration>Setup Valves.
 The Setup Valves window opens (Figure 2-1).
4. Make sure that DJ-Series is selected for Valve 1.
Figure 2-1 Setup Valves