Instruction Manual

Running the VAPR Procedure 11
2.3.2.2 Fluidmove Programming Window
1. Install a clean valve with a new feed tube and fluid syringe onto the dispensing system.
2. In the Fluidmove Main Window, click on Teach a Program.
 The Fluidmove Programming Window opens (Figure 2-13).
3. Click on Setup>Prime>DJ Series Fluid Priming Vacuum Assisted.
Figure 2-13 Fluidmove Programming Window - Setup Menu
 The Vacuum Assisted Prime Window opens (Figure 2-7).
4. Perform Steps 9-12 under 2.3.1 Automatic Operation previously in this section.