Instruction Manual

Running the VAPR Procedure 9
Figure 2-9 Prime Verification Window
 NOTE Click the box next to "With above setups, do verification automatically next
time" to skip this step in the future. A checkmark appears in the box when it is
selected.
13. When the remaining tasks are complete, click on Exit to close the Prompted Setup Window.
2.3.1.2 Fluidmove Teach Window
1. Install a clean valve with a new feed tube and fluid syringe onto the dispensing system.
2. In the Fluidmove Main Window, click on Teach a Program.
 The Fluidmove Programming Window opens (Figure 2-10).
3. Click on Setup> Setup Scripts.
 The Run Script Window opens (Figure 2-11).
Figure 2-10 Fluidmove Programming Window - Setup Scripts
Figure 2-11 Run Script Window