User Manual

28 Maintenance and Service
4. Line up the needle with the inner seal and the jet bearings (Figure 6-23).
5. Slide the needle through the bearings and slide the insertion tool base into the jet body.
6. Hand-tighten the base until it stops against the jet body.
Figure 6-23 Inserting the Needle
7. Line up the installation pin with the hole in the top of the base (Figure 6-24A).
8. Push the pin all the way into the base (Figure 6-24B).
9. Remove the pin (Figure 6-24C).
10. Unscrew and remove the base from the jet body (Figure 6-24C).
Figure 6-24A
Figure 6-24B
Figure 6-24C
Figure 6-24 Detaching the Needle from the Insertion Tool Base
11. Ensure that the flange is below the internal threads of the jet body (Figure 6-25).
Figure 6-25 Needle and Flange Fully Seated