User Manual

26 Maintenance and Service
12. Reset the stroke to the proper value (according to applications requirements).
Figure 6-20 Stroke Adjustment
13. Install the Fluid Reservoir onto the valve.
DJ-9500 Version
a. Install a clean feed tube assembly on the fluid chamber inlet.
b. Install the Fluid Reservoir into the syringe holder and connect the feed tube assembly.
See Figure 5-1.
DJ-9520 Heat Exchanger Version
a. Install the Fluid Reservoir onto the cleaned Heat Exchanger.
b. Install the Heat Exchanger/Fluid Reservoir assembly onto the valve. See Figure 5-2
and Figure 5-3.
14. Install the DJ-9500 on the platform and set-up. See Section 4 – Installation and
Section 5– Setup.
Stroke Indicator Ring
Mark
Cross Hole