User Manual

Installation 9
4 Installation
4.1 Overview
The DJ-9500 is designed for use on Nordson ASYMTEK DispenseMate, Axiom X 1000, Spectrum S-820,
and Spectrum S-900 Series Dispensing Systems. This section includes installation instructions applicable
for each of these systems.
This section includes the following installation instructions:
• Unpacking the DJ-9500
• Installing the DJ-9500
4.2 Safety First
Dispensing system operation involves heat, air pressure, fluid pressure, mechanical and pneumatic
devices, electrical power, and the use of hazardous materials. Refer to the Safety section of your
particular dispensing system manual prior to installing and operating your DJ-9500 Valve.
4.3 Unpacking the DJ-9500
Every care has been taken when packaging your DJ-9500. However, we recommend that you look for
obvious damage and verify contents against the packing slip.
Retain the case for storage of the DJ-9500 and accessories. Retain shipping cartons for future use.
If an item needs to be returned to Nordson ASYMTEK, obtain a Return Material Authorization (RMA)
number from Nordson ASYMTEK.
4.4 Installing the DJ-9500 Valve
If your DJ-9500 valve was factory installed, you do not need to perform this procedure.
WARNING! The procedures in this section should be performed by trained personnel only.
Tools and Materials Needed:
• 4 mm hex wrench
NOTE Prior to installation, use the software or dispensing system position controls to move the
dispensing head to the front center of the dispensing area. Remove any valve currently
installed on the dispensing head. If the valve bracket installed is incompatible with the
DJ-9500, remove it and the Height Sensor (if present). Refer to the installation/removal
procedures in the applicable valve manual if necessary.