User guide

36 Maintenance and Service
To attach the Micro-Adjustment and Cap to the Upper Body (Figure 5-8):
1. Attach the cap to the upper body using the two screws making sure the two notches are aligned.
2. Place the compression spring on the spring retainer.
3. Using the spanner wrench, install the preload locking nut on the preload screw.
4. Perform the next step if the micro-adjustment has been replaced or removed from the
preload screw.
a. Insert the micro-adjustment into the preload screw.
b. Use a hex key to tighten the preload set screws.
5. With the micro-adjustment attached to the preload screw, place the preload screw on the
compression spring and turn it clockwise to attach it to the upper body.
6. Perform adjustments as described in “Settings and Adjustments” later in this section.
Item Description Item Description
1 Micro-Adjustment 5 Hex Head Screw (two)
2 Preload Set Screw (two) 6 Upper Body
3 Preload Screw 7 Cap
4 Preload Locking Nut 8 Compression Spring
Figure 5-8 Installing the Micro-Adjustment and Cap
1
3
2
4
5
6
7
8