Owner's manual

8 Specifications

The specifications below are intended as a convenient reference for personnel involved with installation,

operation, and maintenance of the DJ-100.

This section contains the technical specifications for the DJ-100 Jet. If you have any questions about

these specifications or jet performance, contact Asymtek Technical Support or your authorized distributor.

Table 8-1 DJ-100 Technical Data

Characteristic Specification

Dimensions (LxWxH) 72 x 14 x 60mm

Lubricants like oils and fats, varnishes and colors,

hydrous solutions, organic solvents, liquid polymers and

polymeric solutions and many other liquids

Measureable Material

Measureable viscosity range Approx. 50 – 200.000 mPas (thixotrope)

Quartz powder, iron oxide, aluminium oxide, aluminium

nitrate, nickel, silver, glass and polymericparticles up to

a filling share of max. 50% and grain sizes of max. 50µm

Measureable Filters

Minimum On Time for max. stroke 250 µs (one open and close)

Maximum On Time 500 ms

Resolution 10 µs

Maximum Off Time Infinite (stop)

Dispensing frequency 1000 Hz (not more than 150 dispensing cycles /s)

Dispensing Accuracy Approx. 2% (with constant pressure and temperature)

Maximum Working Pressure 100 bar (10mPa)

Ambient temperature Range Up to 45°C

Up to +100°C (DJ-100)

Up to +180°C (DJ200) (non-boiling media)

Fluid temperature range

Self-adjustable from hard ceramics, removable for

cleaning

Tight Fit Ball / Nozzle

Diameter Standard Nozzle 300 µm, light-blocked (others on demand)

Materials in contact with the piezoelectric

drive

Perflouroelastomer, stainless steel 1.4305, EPDM

Min. Bending Radius R 35mm (one-time); R 100 mm (deliberate movement)

Fastening Thread at the jet body M4; 6mm deep; Tightening Torque: 2.5 Ncm +0.2

Degree of Protection IP 54

Explosion Protection No

Storage temperature -10°C up to +85°C

Weight including connecting cable Approx. 290 g

Suitable Drive Electronics CON100 Amplifier Module (1 jet each)

PDA1, PDA2

Dispensing Process Electronic