Owner's manual

Software Configuration

Once you have installed the DJ-100 on your dispensing system, the dispensing software must be

configured.

WARNING! Only trained service technicians should perform this procedure.

1. Perform a system start-up as specified in the applicable dispensing system manual.

2. Start the Fluidmove software by double-clicking the Fluidmove icon

on the Windows

desktop.

3. Select Configuration > Setup Valves from the Fluidmove Main Window.

! The Setup Valves screen (Figure 4-3) opens.

Figure 4-3 Fluidmove Setup Valves

4. Select Valve 1 (DJ-Series) in the Active Configuration list.

5. Click on OK.

! You will be prompted to restart Fluidmove.

6. Click on Yes

! Fluidmove will restart and you will be prompted to run Valve Offsets. Refer to the

Fluidmove User Guide or Online Help for instructions.