Quick Operations User Manual

4 Introduction

Control Panel

Below are descriptions of C-740/C-741 Series Dispensing System Control Panel buttons as shown in

Figure 1-2.

" NOTE Refer to the Operation section for detailed descriptions of all Control Panel buttons

and functions.

1. Start/Stop Buttons

The Start and Stop buttons are push buttons located on the Control Panel. They control the power

to the dispensing system. The Start button glows green when pushed, and continues to glow until

the Stop button or Emergency Machine Off (EMO) button is pressed.

2. Motion Controls

The Motion Control buttons allow you to manually move the Dispensing Head or the Conveyor.

Press the Robot Enable button to enable communication with the Dispensing Head. To enable

communication with the Conveyor Controller, press the Convyr Enable button.

3. Interlock Keyswitch

The Interlock Keyswitch activates and deactivates the Safety Interlock System. Refer to the Safety

section for additional information.

4. Emergency Machine Off (EMO)

Activating the EMO vents all pressure in the pneumatic system, de-energizes the Robot motors, and

cuts power to all system components except the Computer and Monitor. Refer to the Safety section

for additional information.

5. ESD Grounding Strap Connector

Grounding straps worn by the operator or technician plug into this jack to prevent electrostatic

discharge (ESD) damage to workpieces and dispensing system electronics during dispensing

operations and servicing.

Item Description Item Description

1 Start/Stop Buttons 4 EMO Button

2 Motion Controls 5 ESD Grounding Strap Connector

3 Interlock Keyswitch

Figure 1-2 C-740/C-741 Control Panel