Quick Operations User Manual

Operation 49
Running a Program
Programs can be run from both the ECXP Operator Screen (Figure 3-12 and Figure 3-13) and from the
ECXP Edit Screen. Refer to the Century C-740-C-741 Installation, Operations, and Maintenance Manual
for instructions on running a program from the Edit Screen.
Operator Screen
To run a program from the Operator Screen (C-740 Conveyorized System):
1. Load the program you want to run as described in “
Loading a Program” previously in this section.
2. Click on the Start button.
3. A new product (board or carrier) is requested from the upstream machine, loaded into the fixture,
and coated.
! If a product is present at the coating station when the Start button is clicked, a dialog
box will appear, asking you if you want to coat the product. If you respond No, the
product is unloaded downstream. If you respond Yes, the product is coated and then
unloaded downstream.
" NOTE You can use the Load Product and Unload Product buttons to control the conveyor
manually when not running a coating program. Clicking on the Load Product button
moves a product on the conveyor into the fixture; clicking on the Unload Product button
moves the product out of the workcell.
Figure 3-12 Running a Program - Operator Screen (C-740)