Quick Operations User Manual

46 Operation
2. Click Clear Positions and then click OK to confirm.
! If you have performed a characterization before, the old test area coordinates are used
unless you clear them.
3. Click Next.
4. Click Yes when prompted to teach the substrate height.
5. Teach the substrate height.
a. Install a nozzle on the Fluid Dispensing Applicator and lower the tool until the tip just
touches the substrate.
b. Click Teach Z
c. Click OK
6. Enter the dispense height.
! The following variables should be considered:
- Height of tallest component to be coated
- Width of coating stripe
- Coating material flow rate and viscosity
- Coating stripe overlap
7. Enter the desired rotate position and click Next (for applicators equipped with rotate and cross-
cut nozzles).
8. Enter the desired dispense speed and click Next.
9. Place a characterization sheet (
Figure 3-9) in the workcell and click Next.
Figure 3-9 Characterization Sheet