Quick Operations User Manual

Operation 41
System Startup/Shutdown
These following procedures are offered as general recommendations and suggestions when starting
and/or shutting down your Century C-740/C-741 Series Dispensing System. Your actual start-up and
shutdown procedures may vary.
WARNING! Only authorized service technicians or process engineers should connect power
cables to the power source. Operators should not attempt to make electrical
connections.
Startup
If necessary, refer to the figures in the Introduction section to identify system components.
" NOTE Ensure that all recommended Daily Routine Procedures have been completed prior to
starting the production run. Refer to “Daily Routine Procedures” later in this section.
To start the dispensing system:
1. Verify that the Safety Interlock Keyswitch is in the ON (I) position for production.
2. Close the dispensing system front doors and access covers.
3. Verify that the main power cord is connected to the Main Power Inlet and the facility
power source.
4. Verify that the facility air hose is connected to the Main Air Inlet.
5. Verify that the Facility Exhaust Ventilation System ductwork is connected to the Exhaust
Vent Duct.
6. Turn the Main Circuit Breaker to the ON (I) position.
7. Turn the Computer Power Switch to the ON (I) position.
8. Check the EMO button to see if it has been activated. If it has been activated, deactivate it by
turning the red knob clockwise until the knob pops out.
9. Press Start on the Control Panel (Figure 3-3).
" NOTE The dispensing system turns on after an approximate 60-second vent air time delay.
Verify that the red Vent Air LED on the control panel is blinking. If it is on and not blinking,
the exhaust is inadequate.
! The dispensing system should be in a powered-up state. If not, make sure the power
cord is properly connected to the dispensing system and to an active facility power
source.
! The system computer should begin the boot up sequence.
10. Press System Status Reset and Conveyor Status Reset on the Control Panel.
11. Press Find Home on the Control Panel.
! The Robot should move to the extreme front left corner of the dispensing area.