Quick Operations User Manual

6 Introduction
Dispensing Area Close Up
Below are functional descriptions of C-740/C-741 Series Dispensing System components shown in
Figure 1-4.
1. Board Sensor (C-740)
Mounted on the Conveyor rail within the dispense zone, the Board Sensor detects the presence of a
workpiece entering the system. The signal is sent to the Conveyor Controller, which halts Conveyor
motion and lowers Stop Pins to hold the part in place for dispensing.
2. Chain Conveyor (C-740)
A chain Conveyor is standard on the C-740 Dispensing System. All Conveyors are SMEMA-
compatible. The Conveyor is controlled through the Control Panel and the ECXP software.
3. Stop Pin (C-740)
The Stop Pin is a pneumatic device used to stop workpieces as they are conveyed into the system.
4. Fluid Dispensing Applicator
Depending upon your application requirements, the Century C-740/C-741 Dispensing System can be
configured with any of the Fluid Dispensing Applicators listed in Table 1-1.
Table 1-1 Fluid Delivery Systems
Model Name
SC-104HS High Speed Film Coater (Circulating)
SC-105HS High Speed Film Coater (Circulating)
SC-10XVCS Fluid System, Viscosity Control
SC-204HS High Speed Non-Circulating Film Coater
SC-205HS High Speed Non-Circulating Film Coater
SC-200 Slim Swirl Applicator
SC-300 Swirl Coat Applicator
" NOTE Each of the Fluid Delivery Systems has its own manual. Refer to the specific
manual for the Fluid Delivery System installed on your dispensing system for
detailed installation information.
5. Tooling Plate (C-741)
The Tooling Plate secures the workpiece for batch system operations.
6. Adjustable Tooling Rails (C-741)
The Adjustable Tooling Rails secure the workpiece for batch system operations.