Instruction Manual

4-10 Installation
4.8.4 Installing the Light Beacon
CAUTION! Make sure all power sources are disconnected before performing this procedure.
This procedure should only be performed by a trained service technician.
Tools and Materials Needed:
• 1/8-inch Hex Key
• Light Beacon (P/N LB-C700)
To install the Light Beacon:
1. Locate the Light Beacon and remove all packaging material.
2. Locate the beacon cable access port on the top of the dispensing system (
Figure 4-4).
! The beacon power cable connector extends out of the beacon access port and is held in
place by a cable clip.
3. Use a 1/8-inch hex key to loosen and remove the four mounting bolts around the perimeter of
the beacon cable access port.
! Remove and discard the cable clip.
4. Connect the beacon power cable to the cable on the Light Beacon.
5. Push the cable back down into the access port until the cable and connectors are inside of the
dispensing system.
6. Stand the Light Beacon on top of the dispensing system and align the holes in the base of the
beacon with the holes around the access port.
7. Install the four mounting bolts and tighten using the 1/8-inch hex key.