Instruction Manual

4-8 Installation
4.8.3 Installing the Keyboard and Mouse
CAUTION! Make sure all power sources are disconnected before performing this procedure.
This procedure should only be performed by a trained service technician.
Tools and Materials Needed:
• Keyboard (P/N 194748)
• Mouse (P/N 194459)
To install the Keyboard and Mouse:
1. Unpack the keyboard from its box and remove all packaging material.
2. Place the keyboard on the keyboard tray so that the left edge of the keyboard lines up with the
left edge of the plate.
3. Locate the mouse and keyboard cables in the lower cabinet and remove all
packaging material.
4. Connect the keyboard cable to the cable protruding from the port on the side of the
dispensing system (
Figure 4-3).
5. Locate the mouse and remove all packaging material.
6. Place the mouse on the keyboard plate in the space to the right of the keyboard.
7. Connect the end of the mouse cable extending from the back of the dispensing system to the
mouse cable attached to the mouse.