Instruction Manual

Installation 4-5

4.7 Leveling the Dispensing System

CAUTION! This procedure should only be performed by a trained service technician.

"NOTE If your dispensing system is going to be used as an in-line system, it needs to be leveled

and aligned in relation to upstream and downstream systems. This manual does not

include alignment procedures for upstream/downstream systems. Alignment procedures

should be developed by your facility.

Tools and Materials Needed:

• Adjustable Wrench

• Level

To level the dispensing system:

1. Place a level in the center of the front rail of the Conveyor (X-axis). Use a spirit level, if

necessary.

2. Observe the position of the bubble within the level’s window. The bubble should be centered,

indicating the dispensing system is level from side-to-side.

3. If necessary adjust the Levelers (feet) of the dispensing system as follows (

Figure 4-1):

a. Loosen the locking nut.

b. Turn the adjustment screw in the desired direction until the level’s bubble is centered,

indicating that the system is level from side-to-side.

Item Description

1 Adjustment Screw

2 Leveler (Foot)

3 Locking Nut

Figure 4-1 Leveling the Dispensing System