Instruction Manual

Component Description 3-9
3.8.10 Inline Inverter Module
The Inline Inverter Module provides for a “true” inline process by virtually eliminating manual handling
of the workpiece. Automatic one-or two-sided conformal coating reduces board-handling requirements
and increases yield. The Inline Inverter Module is SMEMA compatible and features a ventilated and
interlocked enclosure. The Inline Inverter Module can be configured for four modes of operation:
1. Bypass Mode – The Inverter passes the workpiece to the downstream system without
inverting it.
2. Normal Mode – The workpiece is inverted and passed to the downstream system.
3. Invert Once Mode –The workpiece is passed to the downstream Century C-740. After one
side of the workpiece is coated, it is sent back to the Inverter. The workpiece is inverted and
sent back to the C-740, where the other side is coated.
4. Invert Twice Mode – The workpiece is inverted and passed to the downstream Century
C-740. After one side of the workpiece is coated, it is sent back to the Inverter. The
workpiece is inverted and sent back to the C-740, where the other side is coated. The finished
workpiece is then passed to the next downstream system.
Figure 3-6 Inline Inverter Module