Instruction Manual

Safety 2-13
To lock out/tag out pneumatic pressure:
1. Press
Stop on the Control Panel.
2. Lock out and tag out AC power as specified earlier in this section.
! When the power is shut off, the Main Air Solenoid Valve shuts off and all hazardous air
pressure inside the dispensing system is automatically released.
3. Disconnect the facility air supply hose from the Main Air Inlet and place a warning tag on the
Main Air Inlet (
Figure 2-6).
Figure 2-6 Lockout of Pneumatic Pressure
WARNING! If your dispensing system is equipped with a heater, allow sufficient time for the
tooling plate to cool prior to performing maintenance or service. Failure to do so
may result in serious burn injury.