Instruction Manual

1-12 Introduction
1.5.1.4 Lower Front Cabinet
Below are functional descriptions of C-740/C-741 Series Dispensing System components shown in
Figure 1-5.
1. Computer
The Computer System is used to create and run dispensing programs with the Asymtek Easy Coat
for Windows XP (ECXP) dispensing software.
2. Conveyor Controller Module (C-740)
The Conveyor Controller module monitors the SMEMA interface and controls the Conveyor
indexing operations. The inputs and outputs are used for sensors, Stop Pins, Board Pins, and
operation of the Conveyor. For more information on the Conveyor, refer to Section 6 - Operation.
3. Tri-Mode Swirl Box (Optional)
The Tri-Mode Swirl Box is a component of the SC-200 and SC-300 Swirl Fluid Systems. It has two
air assist and two fluid regulators and gauges, which regulate the fluid and air-assist pressure to the
fluid applicator. By varying the pressures, conformal coating materials can be dispensed in a bead,
monofilament, or swirl pattern. Refer to 3.9.4.1 Tri-Mode Swirl Box for additional information.