Instruction Manual

1-10 Introduction
1.5.1.3 Dispensing Area Close Up
Below are functional descriptions of C-740/C-741 Series Dispensing System components shown in
Figure 1-4.
1. Board Sensor (C-740)
Mounted on the Conveyor rail within the dispense zone, the Board Sensor detects the presence of a
workpiece entering the system. The signal is sent to the Conveyor Controller, which halts Conveyor
motion and lowers Stop Pins to hold the part in place for dispensing.
2. Chain Conveyor (C-740)
A chain Conveyor is standard on the C-740 Dispensing System. All Conveyors are SMEMA-
compatible. The Conveyor is controlled through the Control Panel and the ECXP software.
3. Stop Pin (C-740)
The Stop Pin is a pneumatic device used to stop workpieces as they are conveyed into the system.
4. Fluid Dispensing Applicator
Depending upon your application requirements, the Century C-740/C-741 Dispensing System can be
configured with any of the Fluid Dispensing Applicators listed in
1.4.3 Fluid Delivery System.
5. Tooling Plate (C-741)
The Tooling Plate secures the workpiece for batch system operations.
6. Adjustable Tooling Rails (C-741)
The Adjustable Tooling Rails secure the workpiece for batch system operations.