Instruction Manual

D-6 Appendix D – Dispensing System Electronics
D.5 Conveyor Controller Rear Connections (C-740 only)
16HFigure D-1 shows the Conveyor Controller on its side to make it easier to read the connections. The
Conveyor Controller stands upright in the bottom of the Century C-740 dispensing system.
"NOTE The controller is not customer serviceable.
Table D-4 Conveyor Controller Rear Connections
Item Feature Description
1 FUSE Fuse holder for 0.125 A 250 V fuse
2 X-AXIS 13-pin D-shell connector, conveyor,X-axis movement control left and right
3 UPSTREAM 11-pin D-shell connector for upstream communication SMEMA cable
4 DOWNSTREAM 11-pin D-shell connector for downstream communication SMEMA cable
5 SENSOR 11-pin D-shell connector for board sensor
6 INTERFACE COM 1, 21-pin RS232 interface connector 201D
7 POWER INPUT
MODULE
Power input cable connector and fuse holder
8 Z-AXIS 13-pin D-shell connector, Z-head up and down movement control
9 DIP SWITCHES 8-position baud rate DIP switch, position 7 turned off
10 RS232C COM 2, 21-pin RS232 interface connector 201 W
11 Y-AXIS 13-pin D-shell connector, conveyor,Y-axis movement control backward
and forward—not used on C-740
Figure D-1 Conveyor Controller Rear Connections
1
11 10 9 8
2 3 4 5 6 7