Instruction Manual

1-8 Introduction
1.5.1.2 Dispensing Area
Below are functional descriptions of C-740/C-741 Series Dispensing System components shown in
Figure 1-3.
1. Solvent Cups
The Century C-740 conveyorized system has two 125 ml stainless steel cups that are installed on
separate brackets mounted to the front Conveyor rail. One cup holds solvent for cleaning the
dispensing needle. A second cup is used for the purging of conformal coating fluid. The solvent cups
can be positioned as desired by the operator on the C-741 batch dispensing system.
2. Dispensing Head (Robot)
The Dispensing Head moves in the XYZ planes. It is controlled through the ECXP software and the
Control Panel. The Fluid Dispensing Applicator, Laser Pointer Programming Tool, and Board
Present Sensor are mounted on the Dispensing Head.
3. Board Pins (C–740)
Pneumatically actuated Board Pins lower into holes in the board to secure it precisely in place for
accurate fluid dispensing.
4. Front Doors
The Front Doors allow the operator to view, and if necessary, access the dispensing area. Door
Sensors connect the front doors to the Safety Interlock System.