Instruction Manual

10-6 Parts Replacement
5. Locate the master link and use the pliers to remove it as described below:
a. Remove the retainer clip (
11HFigure 10-3).
b. Remove the female link (
12HFigure 10-4).
c. Remove the master link (
13HFigure 10-5).
Figure 10-3 Removing the
Retainer Clip
Figure 10-4 Removing the
Female Link
Figure 10-5 Removing the Master
Link (Male Link)
6. Remove any rail-mounted components that interfere with chain removal/replacement.
7. Remove the old chain by sliding it off the conveyor sprockets.
TIP It is recommended that you remove and replace one chain at a time to ensure that
all parts removed from each rail are re-installed in their exact same locations.
8. Use isopropyl alcohol and clean swabs to clean all metal surfaces that make contact with the
chain, including sprockets and rails.
9. Install the new chain onto the sprocket rail (
14HFigure 10-6).
Figure 10-6 Installing the Chain on the Sprocket Rail