Instruction Manual

9-12 Maintenance

Tools and Materials Needed

• Torque Wrench (P/N 199447)

• Allen Wrench 9/64

CAUTION! The Robot will move during the tensioning process. Keep clear of the Robot

during the movements. Enter the dispensing area only when prompted to do so.

To tension the cables:

1. Perform a system startup as described in 6.9.1 Startup.

2. Depressurize Fluid System by turning off air pressure to Fluid Reservoir.

3. Remove the right side cover of the machine.

Item Description

1 Right Access Panel

Figure 9-6 System Access (Rear View)

4. Load ECXP and select Edit > Edit Mode to open the ECXP Edit Screen.

5. Click on

Utilities > Robot Utilities > Tension Procedure.

! The C74X Tension Procedure opens (

Figure 9-7).