Instruction Manual

9-10 Maintenance
9.5.6.2 Lubricating the X-Axis Bearings
To lubricate the X-axis bearings:
1. Move the Dispensing Head to the front of the system, using the motion control arrows on the
front Control Panel.
2. Lower the Dispensing Head and turn off the dispensing system.
CAUTION! Make sure the Fluid Applicator does not contact the substrate when you lower
the Dispensing Head.
3. Open the front doors and locate the access hole on the front of the X-axis bearing housing.
See
Figure 9-5.
4. Put the tip of the grease gun against the access hole. Pump once or twice to inject grease into
the X-axis bearing housing. Stop when grease extrudes from the ends of the housing.
5. Clean and wipe the X-axis guide rods, using an ammonia-based cleaning solution.
6. Repeat the procedure for the rear guide rod.
Item Description
1 Guide Rods
2 Access Hole
3 X-Axis Bearing Housing
Figure 9-5 Lubricating the X-Axis Bearings
1 2 3