Instruction Manual

Maintenance 9-9
9.5.6 X-Axis Lubrication
Lubricating the X-axis bearings on a quarterly basis will ensure smooth Dispensing Head movement and
prolong bearing life.
Tools and Materials Needed
• Grease Gun, 16 oz. Cartridge (P/N 09-2010-00)
• Grease Fitting (P/N 43-1064-30)
• Grease, Linear Lube (P/N 48-0019)
• Ammonia-based Cleaner
• Soft Cloth
9.5.6.1 Loading the Grease Gun
To load the grease gun:
1. Pull the grease gun handle back until the locking tabs are visible.
2. Twist the lock into position.
3. Unscrew and remove the top of the grease gun.
4. Remove the cap from the grease cartridge and place the cartridge open end down into the
gun cylinder.
5. Pull the tab to remove the seal from the bottom of the grease cartridge.
6. Replace the top of the grease gun, and screw the extension into the front side at the top of the
grease gun.
7. Release the handle from the locked position.
8. Purge the air from the grease gun cartridge by dispensing grease until a solid stream flows
from the gun.