Instruction Manual

Maintenance 9-7

9.5.4 Cleaning the Fluid Filter

To clean the Fluid Filter:

1. Turn the Reservoir Air Pressure Pneumatic Switch to the OFF

(0) position. See Figure 9-3.

2. Relieve residual pressure in the Fluid System by opening the Pressure Relief Valve on the

Fluid Reservoir.

WARNING! To prevent eye injury or irritation, wear safety goggles while performing this

procedure.

3. Unscrew the Fluid Filter cap.

! The Fluid Filter is located inside the housing.

4. Remove the 150-micron in-line filter and clean it with a proper solvent.

5. Brush the stainless steel screen with the appropriate solvent. Replace if necessary.

6. Blow filter surface with compressed air.

Item Description

1 Fluid Filter Cap (left rear)

2 Reservoir Air Pressure Pneumatic Switch (right rear)

3 Fluid Reservoir Pressure Relief Valve

Figure 9-3 Cleaning the Fluid Filter