Instruction Manual

7-16 Configuration and Characterization
7. Click on the Comm Port tab. Make sure the Host Port settings are:
• Baud Rate: 9600
• Parity: Even
• Data Bits: 7
• Stop Bits: 1
• Auxiliary port: Disabled
8. Click on the
Protocol tab.
9. Set
Selected Protocol to Point-to-Point and check the RTS/CTS box.
10. Enable the
Postamble and set it CR and LF.
11. Click on the
Output tab.
12. Set the
Beeper status to On Noread. Choose Volume Level 5.
13. Click on the
Apply button on the bottom of the window.
! The Save window opens.
14. Click on
Send/Save.
15. Click on
OK.
16. Click the
Send/Recv button and then on the Receive From Scanner button to obtain the
scanner's settings.
! This updates the yellow Current Menu/Scanner Settings window.
17. Scroll down to make sure that the correct settings have been received from the scanner.
18. Exit the MS810 ESP utility.