Instruction Manual

Configuration and Characterization 7-7
17. The settings will be displayed for your approval. The only variable you can change is the
stripe width. To change any other settings, you will have to rerun the characterization.
TIP To perform a characterization from the ECXP Edit screen, click on Configure > Tools.
The Tool Configuration dialog box opens. Select the tab for the tool you wish
characterize, then click the
Configure button.
7.6 Fan Width Configuration
If your system is equipped with the optional Laser Fan Width Control feature, you will need to perform a
Fan Width Setup. For additional information, refer to the manual for your Laser Fan Width Control
System or contact your Asymtek representative.
7.6.1 Fan Width Setup
Before configuring the fluid fan width, you must perform a tool configuration and characterization. Refer
to 7.4 Tool Configuration and 7.5 Characterization for detailed instructions.
" NOTE Fan Width Control is available only for the Select Coat Tool. For more information,
contact your Asymtek representative.