Instruction Manual

Operation 6-31
6.12 Running a Program
Programs can be run from both the ECXP Operator Screen (Figure 6-14 and Figure 6-15) and from the
ECXP Edit Screen (Figure 6-16). Following are detailed instructions on running a program from both
screens.
6.12.1 Operator Screen
To run a program from the Operator Screen (C-740 Conveyorized System):
1. Load the program you want to run as described in 6.11 Loading a Program.
2. Click on the
Start button.
3. A new product (board or carrier) is requested from the upstream machine, loaded into the
fixture, and coated.
! If a product is present at the coating station when the
Start button is clicked, a dialog
box will appear, asking you if you want to coat the product. If you respond
No, the
product is unloaded downstream. If you respond
Yes, the product is coated and then
unloaded downstream.
" NOTE You can use the Load Product and Unload Product buttons to control the conveyor
manually when not running a coating program. Clicking on the
Load Product button
moves a product on the conveyor into the fixture; clicking on the
Unload Product button
moves the product out of the workcell.
Figure 6-14 Running a Program - Operator Screen (C-740)