Instruction Manual

5-16 Power-up and Testing
5.10 Dispensing System Options
Perform the following ECXP commands to make sure that the various dispensing system options are
functioning properly.
5.10.1 Laser Fan Width Control
If the system is equipped with Laser Fan Width Control, you may use ECXP to test and adjust pressure
as follows:
1. Select
Edit > Edit Mode from the ECXP Operator Screen to access the ECXP Edit Screen.
2. Select
Utilities > Pressure Adjust from the menu bar.
! A cascading menu listing the tools configured for your system opens (
Figure 5-14).
" NOTE Menu choices will vary depending upon system configuration.
Figure 5-14 ECXP Edit Screen - Pressure Adjust Menu
3. Select the desired tool.
! The Pressure Output dialog box opens. This dialog box is used to test and adjust
pressures (
Figure 5-15).