Manual

Startup/Shutdown 5-3
(Continued)
14. Select Valve Offsets, or Calculate Master Offsets.
> If the Calculate Master Offsets command is grayed out (not available), go back to Needle
Setup, select Needle Setup Parameters, click on Calculate Master Offsets, click on OK, then
repeat this step.
15. Follow the on-screen prompts (see your Fluidmove manual) until the offsets routine is
complete.
> If you have any questions, consult the On-line Help.
16. In the FmNT Main Window…
> Click on Teach a Program to create or edit a production program. See your Fluidmove
manual for more details. (STOP HERE)
> Click on Run a Program to run a production program. This brings up the Production
Window. (CONTINUE BELOW)
17. In the Production Window, click on Load.
18. Select the program you wish to run.
19. Click on OK. This loads the production program into memory.
20. Click on Run.
21. Select Run Production. This brings up the Run Window.
22. Click on Go. This activates the dispensing process.
End of Procedure
See the Fluidmove
®
for Windows NT Installation & User Guide for further instructions.